I know it’s been awhile, I have something to show you if you don’t mind? I’ve been working on one of my old ideas. Sunk about £1000 into it so far because coils and magnets make up most the costs. It a 4ft wide gravitational potential generator. That perhaps could bolt into any rotary rig? Be that air gen or ground gen? In the process of building the second one. Loads more work to do. Making sure the coils are equidistant is just but one challenge. Soldering is another but could alway farm out the work where I may not be able? So far there is 15 coils per unit so 30 coils in total. 20 n42 neodymium spherical magnets in each unit making 40 Magnets in total. The idea could be used in a nested configurations or stacked like a kite train? It might also do well from central supports? As with all those coils on the tubing it tends to go into an oval. Which I think might be counter productive? So I’d like to throw this out there for feedback and if anyone is willing a collaboration? as I know it might just bolt in to some of the rigs I’ve seen on here? For a few lucky one I might just post it to you if you would like to have a play with it? I’ve got it this far with alot of choice words and cursing. The coils were especially tight to fit manually. Have had a lot of fun doing it so far from my kitchen! Any help or assistance is welcome. I hope you all like what you see so far after my time away? Just thought I’d share, as you never know where it all might leads to?
